I checked ALL the caps (unsolder and put on the cap tester for value and leakage, I had one dodgy cap, about the 3rd one I checked, but anyway replaced that one, one I could not test for leakage at 16v (only had 25 as the lowest) so I tested at 25v, the eye would not open all the way so I replaced it any way.
Now I got a picture and raster!
BUT I also have vert size issue, only getting about 1/4 fo the screen to fill in.
So I think I will pull the deflection board next and go thru it.
All of a sudden I am starting to like this set
