|
It was the resistor!
I clipped out the old resistor in line with D6, temporarily tacked a new 4.7 ohm 5W wirewound under the board, and the set came right up!
There seems to be one issue from the get-go. The CRT seems to be a bit out of focus around the edges. Is there a way to adjust this, or is it just a weak tube?
__________________
This device isn't a spaceship, it's a time machine. It goes backwards, and forwards... it takes us to a place where we ache to go again.
Last edited by fsjonsey; 01-18-2010 at 10:21 PM.
|