Quote:
Originally Posted by jr_tech
I think that I also see some keystone from left to right (yoke alignment?) or perhaps some voltage shifts? Are power supply voltages, boost, HV constant ? or do they change with the horizontal position of the beam?
jr
|
The key-stoning was there with the 10MP4 also, but it didn't have the focus issue and it was centered horizontally. I'll have to check the supply and the boost. The HV will be constant if the power supply is since it's an RF oscillator type. At least it wouldn't be coupled to the horizontal.
It could be the power supply. Since I had to make a large horizontal center adjustment, and the pot that does that also drops the 180V to supply 170V to other sections, it could now be affecting the 170V that I boost to 250V. The 170V is also supplied to the vertical output stage.
Until I'm able to secure the CRT I won't be able to do any measurements under the chassis.
It's probably not related, but right where the screen gets blury is where the right edge of the scan stopped until I recentered it.
John