View Single Post
  #19  
Old 01-04-2010, 09:52 PM
rollei35guy rollei35guy is offline
...
 
Join Date: May 2008
Posts: 86
Quote:
Originally Posted by Adam View Post
I finally looked at this 1957 RCA clock radio I got when I started this thread. I had assumed the clock was like the others I had seen, where the mechanism is sealed, but that wasn't totally the case here, couldn't get it totally apart, but got a cover off and got in there enough to squirt some WD40 in there, which so far has quieted it down.

The radio portion had a corner broken off the circuit board, but I glued it back together with super glue, waited until I was sure it was dry, then just added solder across the one trace that went across the corner, I was going to add a wire in it's place, but it soldered up good, so I left it like that. Other than new caps, the radio just needed a new 50C5 to replace the one in there with an open filament. Now I finally have a good old, quiet clock radio.
Does that disk on the back of the radio spin out in the open? I've seen a couple of clocks like that but not, so far, in a radio.

That's a nice looking radio you have there. Very clean.
Reply With Quote