View Single Post
  #17  
Old 01-03-2010, 12:32 AM
Adam's Avatar
Adam Adam is offline
VideoKarma Member
 
Join Date: Oct 2005
Location: Phoenix, AZ
Posts: 2,383
I finally looked at this 1957 RCA clock radio I got when I started this thread. I had assumed the clock was like the others I had seen, where the mechanism is sealed, but that wasn't totally the case here, couldn't get it totally apart, but got a cover off and got in there enough to squirt some WD40 in there, which so far has quieted it down.

The radio portion had a corner broken off the circuit board, but I glued it back together with super glue, waited until I was sure it was dry, then just added solder across the one trace that went across the corner, I was going to add a wire in it's place, but it soldered up good, so I left it like that. Other than new caps, the radio just needed a new 50C5 to replace the one in there with an open filament. Now I finally have a good old, quiet clock radio.

Last edited by Adam; 05-11-2014 at 07:34 PM.
Reply With Quote