|
There are a couple small transistors close to that cap that may be bad. In fact, MAT electronics sells a kit that contains the HOT, the two transistors, and the cap for these sets. As you've found out, it doesn't take much to wreck that PC board - very cheap made. If the HV comes up, if only for a second, the HOT is good. I'd probably check/replace those two transistors close to that cap. The vertical output IC may be shorted. I haven't seen it in these sets; but, I have seen them short in other newer sets and cause the power supply to shut down. Just remove the IC and see if the set comes on with no vertical deflection. If it does, replace the IC and electrolytic caps associated with it. There could also be a shorted diode off the flyback transformer or secondary of the switching transformer. IIRC, these sets will also shutdown if the G2 control on the flyback is not set correctly. I'm sure those blinks are an error code; but, I have no idea what it means. If these steps don't correct the trouble, I'd probably forget it. Philips/Magnavox sets really took a nosedive in quality in the late '90's and they've only gotten worse since then.
|