[DaveWM]

response to Charlie

Originally Posted by Charlie

Does the dot crawl only stay at the very top?

Dot crawl is through out the pic

How far beyond the mask does the picture go?
its pretty close, have expanded it some, still have the issue


If you have the picture spread only to the edge, you're bound to find stuff there. The picture should go at least a half inch beyond the mask.

Are there any caps/resistors left in the verticle section that you haven't changed?

have checked all resistors, replaced any leaky caps (replaced 2 that were slightly leaky(, did NOT check the disk caps.

Does this set use one of the combination components in the verticle section?

yes it does I have comtemplated making one up, would not be hard to do. I have some scrap perfboard that would make it easy to do.


If so, maybe you need to build a new one. I figure you've already done this, but I'll mention it anyway... cleaning the verticle pot with some spray?

Can't recall for sure, will give it a shot to be sure.