|
giving the TV a break, pulled the TT (platter would not spin). the idler wheel had a big flat spot AND a nice divot (where the motor spindle must have been resting for years). The tone arm Ilder was still somewhat pliable, and I was able to work its slight divot out, but the platter ilder divot and flat were a whole nother matter. the rubber was rock hard. I chucked it up in the lathe and took off enough to get down to the bottom of the divot (the flat wa not as deep so it was gone by then). prob took just a bit less than 1/8 total off the diameter. I then found a suitable rubber band (from a broccoli plant) and placed it around the idler wheel. Its prob only at most 1/32" thick but nice tack to it. Tried it out, works great. I also found a MPX on epay so that will be here in a couple days. It's a nicer one (3 tuber) prob need a filter and a single coupling cap (it has a 1uf in there that goes bad). I will put it in and then take another look at the TV.
I am tempted to install a magnavox color TV (tubes of course) that I may be able get locally. the cabinet is shot so it would not be a sin to use it, except for the fact that this would then be a franken set.
|