View Single Post
  #2  
Old 12-08-2009, 11:14 PM
YamahaFreak's Avatar
YamahaFreak YamahaFreak is offline
<-- CSXT 6038, EMD GP40-2
 
Join Date: Dec 2005
Location: TOO sunny Florida, USA
Posts: 580
Quote:
Originally Posted by crtfool View Post
I know that others have said that using water on electronic circuitry is not harmful, but I would never have done that on purpose - there are circuit board cleaning and degreasing sprays that are non-conductive and they evaporate very quickly so that they can be sprayed on live powered circuitry with no danger or damage at all. Since you did use water, it would have been a good idea to let them dry completely for a few days before trying to power them up.

Unfortunately, you let the smoke out of at least 1 or more components - and even though nothing looks burnt, they are damaged and will no longer work properly, or even within critical safety specifications. On all manufacturer service documentation, and even third party service manuals, critical safety components are usually identified as such with at least an exclamation point symbol.

If you do attempt to continue troubleshooting this set, PLEASE proceed with extreme caution from this point on.
This is not encouraging. I needed to use water because the coolant was everywhere, and probably would have been near impossible to completely remove otherwise. I'm not sure where the smoke came from, but I will take a closer look tomorrow. It seemed to emanate from the general vicinity of the audio amplifier. Hopefully, it's something simple(capacitor, resistor, etc.).

Does anyone know of a place where I might find schematics for this set?

P.S.--Is that a CRT from a video camcorder viewfinder in your avatar?
__________________
Sony Trinitron Fan
Reply With Quote