View Single Post
  #4  
Old 12-03-2009, 09:39 AM
DaveWM DaveWM is offline
VideoKarma Member
 
Join Date: Feb 2009
Location: Orlando FL
Posts: 5,607
no change after jumping a new cap on that HOT screen.

think it is time to break out the scope and snoop around. I will check the wave pattern on a good set (same chassis) vs this one, on the grid of the vert output tube. then I will adj the vert hold so I get the over lap, that way I hope I can see what the pattern looks like, and if I can see the diff.

one thing I was checking was the voltages of the vert out, 0 on grid, 22 on cathode, all 3 of these chassis have this result, yet the sams say should be
-2.7 and 15. I have checked both the coupling cap and grid leak resistor, both ok. I tried different tubes, including some NOS (thinking it may have been gassy), I get some different cathode voltages (20-23) but the grid is always 0. I check with a DMM and a VTVM with and with out video signal.

The DMM would show millivolts some neg but very small like -50mv and it would jump around.
Reply With Quote