View Single Post
  #23  
Old 11-16-2009, 07:16 PM
DaveWM DaveWM is offline
VideoKarma Member
 
Join Date: Feb 2009
Location: Orlando FL
Posts: 5,607
hmmm since its not shorted, and the only problem is the blanking leg, perhaps I can work around that and get the blanking off the yoke windings. I have seen a couple schematics like that, looks like some kind of voltage divider used to tap the yoke windings. 1st though is I have to see if the vert osc is working, and if not why. I am assuming the blanking being open would not stop the osc, but maybe I just cant see it if its getting blanked out I do get some vert on the raster, but most of the CRT is blacked out, just a smudge of raster about 1/3 high and about 1/2 wide. I don't know enough about the blanking signal to know if this could be caused by the open leg.
Reply With Quote