Thread: Zenith 20Y1C38
View Single Post
  #15  
Old 11-14-2009, 08:36 PM
DaveWM DaveWM is offline
VideoKarma Member
 
Join Date: Feb 2009
Location: Orlando FL
Posts: 5,607
Sucess!

I used the auto restore mode, the red gun came up and is much closer to the others. I did not understand the tracking control very well will have to re read that, but for now the CRT is looking pretty darn good (have convergence issues on the sides, but I dont want to tackle that with out a Sams or service manual).

Of course as with Klatu, no way of telling how long the restore will last.

Doug, the jumper is in the aft most postion (closest to the back of the chassis). there was some paper there, but it is torn and I cant tell which jumper setting is correct. I can see ther two arrows printed on the paper but the tear is such that it does not tell which arrow is correct.

The KV is about 27, there is a warning about not going over 25. think it could be set wrong?

I assume the cathode current is checked in the normal manner (on the HOT) for current, that is lift the connection and read with a .47 bypass cap in P with the meter leads. Can you tell me the spec current range?

hopefully this CRT will last and I will be able to just hang on to that 23VEP22 as a spare.
Reply With Quote
Audiokarma