|
You're statement about lacquer is correct-each new sprayed on layer melts into the previous ones. This can go both ways, as the flaws from each layer will add up, but you develop a beautiful, deep finish in the process. In sanding lacquer down to use as a grain filler, I have had little luck. Those little cans from Mohawk are pretty expensive, and I can buy Bullseye shellac from any hardware store for about half the price. The shellac seems to sand down much more nicely. For instance, I had a small run appear on the shellac with this cabinet. I simply buffed harder with the steel wool in this spot, and the run went away. If I did that with lacquer, I would have created a hole in the finish.
I have only used shellac to do what I would describe as a partial piano finish-the grain is filled in enough so that you have a nice highly reflective quality to the wood, but if you look at the finish from the right angle, some of the deeper grain is still apparent in the finish. There are many ways to truly fill grain, all of them difficult. Perhaps I will write about that a bit more later.
To answer your other question, yes, those are little vinyl robots on the wall in the background-also note our Philco Radiobar is also visible in the background as well.
|