|
Those older German radios were excellent. I never heard of or saw a "Kaiser" radio, however, until now. It looks like many of the early German sets such as Grundig, et al.; should be an excellent performer once you get it working. I had a Grundig 2168 AM/FM/SW four-band radio some 30 years ago that worked well (and sounded great), except for the fact that the side speakers were missing, until the FM tuner quit; never did figure out what happened to it. Got rid of it when I purchased my first stereo system in the early 1980s.
Zenith may have taken their cues from the Germans when the former designed their better table model radios (C/H/L845, C835, K731, MJ1035, et al), as these sets sound every bit as good as the German ones, especially since the Zenith radios I mentioned have two speakers, one for lows and midrange and a smaller one for the highs. Zenith also used a special type of audio output transformer in their better table sets; this transformer had a feedback winding (for want of a better phrase; I can't think of the right one offhand) which most garden-variety AA5s do not have. Moreover, Zenith radios of the '40s through the end of the sixties had "true" tone controls that actually varied the entire response curve of the audio stages, rather than simply cutting down the high frequencies as do most tone-control schemes; this contributed to the outstanding tone quality of these sets, compared to today's one-chip gutless-wonder plastic headphone stereos and portable radios.
As to your Kaiser set, the switches and controls can be cleaned with Deoxit or even standard contact cleaner as is (or was) availiable at Radio Shack. After 50 years, I'm not surprised those buttons are intermittent. For the dust on the chassis, it can be vacuumed and brushed out easily. I have a Zenith H511 table set, an eBay score some years ago, that was very dusty inside when I got it; obviously the radio's former owner must have tucked it away in a garage, basement, attic, etc. for decades and forgot about it until he or she put it up for auction. Sounds like that may have been the case with your Kaiser radio as well; whomever had it before you may have had it in storage and left it there for years.
If it hasn't been tested already, I would be extremely cautious about testing this radio. The standard practice, plugging it into a Variac (a variable-voltage autotransformer) and bringing up the voltage slowly, watching for sparks, smoke, etc. as the voltage is increased, should be used here. If a Variac is not available, a common 100-watt light bulb in series with the line cord will suffice. This bulb should light to normal brilliance if there are no major shorts in the power supply. However, if the bulb lights to full brilliance, then promptly burns out with a bright flash (akin to a camera flashbulb), there is a short somewhere in the radio that must be identified and cleared before the set can be used again.
__________________
Jeff, WB8NHV
Collecting, restoring and enjoying vintage Zenith radios since 2002
Zenith. Gone, but not forgotten.
|