|
About 17 years ago, a friend gave me a nice VCR that was dead - no display, and no LEDs lit up when plugged in. I replaced a blown 2A fuse, which blew immediately when I plugged the VCR in. I tested all the power supply components, but could not find anything that was shorted or obviously defective. I tried another 2A fuse, then a 3A and a 4A - same result. I was determined to find the cause - it was the VCR or ME, and I was not going to lose to a stupid machine. I connected my multimeter to the fuse holder and set it on the 10A high amperage setting. Plugged in the VCR and stood back - the VCR powered up briefly, the meter quickly rose to just above 7 Amps, and then 1 of the transistors on the power supply exploded! I replaced the transistor and put in another 2A fuse - VCR worked perfectly for about 5 years after that without any problem.
BTW - I would never use a paper clip, piece of wire, or tin foil to bypass a fuse!!!!!!!!
|