View Single Post
  #24  
Old 10-30-2009, 04:48 PM
mbates14 mbates14 is offline
VideoKarma Member
 
Join Date: Apr 2004
Posts: 1,016
if its intermittent, ill tell you what the problem is. soldering. period.... no matter what.

easiest way to resolder a flat-pack IC such as the micro, is take a thing of solder paste, the stuff you refrigerate, use a needle tip, put a tiny bead on all 4 sets of pins. then take a hot air rework station, about 25% air, 75% heat adjustment, and then take the smallest gun tip you have, like i do, and gradually blow toward and go down the set of pins. it will re-do solder on all pins, using a lighted magnafier, wick up any potential cross-over.

if you are going to repair any of these kinds of electronics, you must have a rework station, thats about the jest of it. and by looking at your high-res photo, i can see some cracking of the pins of the CPU because of the heat issue. plus its not a bad idea to reflow the DRAM IC.

Last edited by mbates14; 10-30-2009 at 04:58 PM.
Reply With Quote