View Single Post
  #6  
Old 10-19-2009, 01:52 PM
Eric H's Avatar
Eric H Eric H is offline
Administrator
 
Join Date: Jun 2002
Location: So. Calif
Posts: 11,565
I took it apart this morning, not too dirty inside but it's dusty and stinks of cig smoke.

I decided the only way it was going to get really clean was to give it a bath sooo...
I filled the sink with warm water and a little Purple Cleaner, (undiluted Purple Cleaner will dissolve Bakelite) and tossed the chassis in.
It came out clean and all the labels survived intact.

Everything on it is metal, plastic or rubber so getting it wet for a brief period shouldn't be a problem as long as I dry it our for a week or so.

The front control pots turn freely if you can grab them by the shaft but when it's in the cabinet and you have to turn them by pushing on one side of the knob they are really stiff (this is before washing them) does anyone have any ideas what I should lube them with, Silicone? Tuner Grease? I was wondering if I should take them apart and put grease on the insides or just shoot some control cleaner/lube through the holes?

These have plastic shafts and metal housings, perhaps that special lube used for sliding controls would work?
Reply With Quote