View Single Post
  #9  
Old 10-05-2009, 01:03 PM
Charlie's Avatar
Charlie Charlie is offline
On Land
 
Join Date: Aug 2002
Location: Warren, TX
Posts: 2,582
Question: If you're rebuilding a can with the cardboard sleeve, the sleeve must remain?

I am working on a can right now that had the sleeve. Under the sleeve, I found the markings on the aluminum can were not the same markings as the sleeve. For instance, the cardboard sleeve showed capacitor values for two sections... a 5 mfd and a 200 mfd. After removing the sleeve, the can underneath showed values for four sections... none of which matched the cardboard sleeve.

At first, I thought they were just correcting the values by covering up the original markings. Then, after looking at the schematic, I noticed the can (serving as the negative side of the capactitor) would have a voltage on it from somewhere further along in the diagram.

Of course, I had to tear the sleeve of my can because it was held on the can with the tar. I suppose I will have to use a toilet paper roll to slide back over the can.

So, if there's a cardboard sleeve, it's important to return the sleeve? Or am just making more work for myself?
__________________
Charlie Trahan


He who dies with the most toys still dies.
Reply With Quote