|
Changing the focus divider is easy, if you can find one that hasn't gone bad from time and deterioration of the plastic... The anode cap has a phillips screw in it (contact side; between clip), and you loosen that and pull the focus wire out. The other wires are soldered to their destinations, and covered with a glob of silicone rubber (a must to do, or it will arc). However, what I always did, was to replace the high voltage tripler with a newer one (ECG 256a or NTE526a), which has a tap on it for the focus voltage, thus eliminating the divider altogether. Consult the schematic for a Zenith 19EC45 for the wiring change (simple).
Charles
__________________
Collecting & restoring TVs in Los Angeles since age 10
|