View Single Post
  #17  
Old 09-15-2009, 10:31 PM
bgadow's Avatar
bgadow bgadow is offline
VideoKarma Member
 
Join Date: Oct 2003
Location: Federalsburg, MD
Posts: 5,865
I got that Sams in the mail, a day late. I jotted down the yoke part numbers if you need them (not in front of me though.)

There is a trick for testing the vertical circuit on older bw sets, not sure if it will work on this though. You connect a cap (like a .047) from the filament to the vert osc. tube grid. This is where I have to check my notes-if you get deflection at one grid it points to the osc xsfmr, the other grid it is the output xsfmr.

You can disconnect the leads from that transformer and see if it is open with an ohmeter. That photo sure looks like a yoke. I would think many Zenith yokes would be close enough. When I was around 18 I had a couple Zeniths, one very close to yours, another that was probably among their first rectangular models. I had the newer one working fine but couldn't coax any life out of the oldie. One day I decided to swap the chassis. Biggest issue was that the yoke connectors were different. I didn't have a schematic to go by (and probably couldn't have read it, anyway) so I did the best I could splicing them. I crossed my fingers and actually got a raster, but never did anything else with it.
__________________
Bryan
Reply With Quote