Quote:
Originally Posted by electronjohn
I always enjoy your restoration play-by-play, sir! Hats off to you!
|
I'm glad you like my style.
Here's another exciting installment!
I managed to salvage the vertical center HV pot extender with a little epoxy cement and it's usable again.
The cardboard sleeve from the cap I roasted in the oven didn't survive the experience. So, I fabricated a replica using a toilet paper roll and glue.
I then spray them all with a little flat black paint - they look a lot darker in person.
I considered masking off that corner of the chassis and touching up the black paint, but decided it wasn't worth it.
Next, I cleaned up that copper plating a bit.
I also replaced all 10 missing HV cage screws. Every set I have seems to be missing at least half it's screws!
Here she is all cleaned up
Next, I tackled the plastic faceplate with some Novus #2
Good as new!
This set is missing the bottom pan and the rear cover. Here's they are from another set. The bottom tray should be easy to fabricate with some sheet aluminum. I'm not sure about the steel rear cover other than using a piece of sheet steel and giving my drill press a real workout.
Any ideas?
Finally, I tried to make some decals. I've attached the image file I created.
I printed that out onto some special decal paper and sprayed it with several coats of clear gloss acrylic as indicated. Looking good so far.
Ugh, I accidentally ordered the wrong decal paper

Opaque white backing instead of clear.
On the bright side, it seems to work fine on my scrap sample.
Here's a preview of the set while I wait for the proper decal paper to arrive. I still have a little work to do on the cabinet. Touch up the top front finish, apply the decals and give it a couple coats of lacquer. Also the CRT isn't firmly seated yet.