I've begun work on restoring the rest of the set.
Here's the original cabinet with the faceplate and control area removed.
I stripped it with CitriStrip and Mineral Spirits. Lightly sanded it, masked off the center portion and stained the rest with "Golden Pecan". I think it's a pretty good match to the original. Once it's dry, I'll used a few coats of gloss lacquer.
The original CRT mask is just too crusty and crunchy to use. So I grabbed one of the last reproduction masks from
renovatedradios.com
Apparently the mold broke, but he still has a master molded in hard plastic. You can email a request and when he's received enough, he'll do another run.
I repaired a small tear in the speaker cone using this
simple technique
Knobs, knobs knobs! I have 3 Motorola 7" sets that need complete sets of knobs. Mahogany, Blonde, Bakelite. Here's the knobs I have.
Here's my guestimation
Far-left is from a Motorola 9VT1 like this
one
The center group of brownish knobs is for the mahogany and blonde. Not sure about the darker/lighter brown or the circular inset color.
Swirled, tan smaller knobs - no idea!
Finally, my lone golden knob for the bakelite set courtesy of Zenithfan1 (thanks Mark!)
If anyone can verify which knobs go with which set, I'd be very grateful. I'm also open to trading. All I need is 3 complete sets.
Here's what various combinations look like on this set. That's my restored photo finish on the control area. Took for
freakin' ever to get it right. It's still not perfect, but I've spent way more time than I ever expected on it.
I wonder why Motorola use a photo finish for the front on the blonde sets? Maybe a rare wood was used? The Mahogany set is veneer all round.
Finally, I'm going to try making some custom decals for this set. It's similar to the repro decals sets that are out there in gold lettering, but this set needs brown lettering. Also channels 1,2,3-4,5-6,7,8-9,10,11,12-13.
The idea is that you print onto this special pape and, spray a few coast of clear, gloss enamel over it. Once it's dry, you can float the paper in water to release the decal like normal.
I hope it works out well, I have a few other sets that could use new decals.