|
The one thing I am curious about is the fact that the diagram shows one 470ohm resistor and a 47mmf cap in the yoke all my set had was a burnt in half cap-no resistor.I have put about 12 hours on this set. The pic is quite good except for the lines which you can't always see.Plus the yoke does not get hot.My book says these lines are a damper circuit issue. Ok, My damper circuit is only one tube-and 4 wires, 2 to the tube heater. 2 to the functioning part of the tube. I have subbed in a diiferent tube from a good set. This is confusing
|