View Single Post
  #9  
Old 03-07-2005, 07:38 AM
RetroHacker RetroHacker is offline
Electronics Accumulator
 
Join Date: Jan 2005
Location: Niskayuna, NY
Posts: 464
Well, I had a little bit of time this weekend, and I pulled the chassis out of the console, and dragged it down to the workshop. I haven't really done much in the way of troubleshooting here, since I didn't have much time to work, but I've cleaned it a bit, and looked around, getting myself familliar with it's layout. This is by far a much more complicated chassis than any of my previous projects, I've worked on several black and white sets, mostly Zenith - with their beautiful metal chassis/hand wired design. This set has printed boards, and many bundles of wire. Of course, this is also the first tube color set I've worked on...

OK, so, I measured the resistance between the hot and neutral on the power input when the switch was set to ON. Less than 1 ohm - not good. It didn't do this before I fixed the wiring, when the power resistor was disconnected, underneath the chassis when I first found it. All the tubes lit up before. This is good, since that means that my power transformer has a good chance of being OK. Also, the flyback looks to be in good condition, physically anyway - it's not burnt or cracked, and it's not even too dirty, since it's inside that nice little metal cage. The offending resistor - the one that had been disconnected at a burnt terminal strip is connected to what appears to be some sort of choke or transformer, which is connected to the shunt regulator tube, a 6EN4. Removing the tube does not clear the short, so I've likely got something electrolytic that's shorted. Attempts to trace the wires from the shunt regulator back to the power supply were unsuccessful, the wires are tightly bunched together, and some have faded a bit, making identification difficult.

I don't have a schematic for this set, since some <explicative deleted> stole it out of the public library. This is a CTC38XK, Sams #1092-3. Looking up on Sams website, I see that there is also a Sams #1000-3, which covers the CTC38X, XAD, XAE, XP, XR, XT, and XU. What's the difference here - is it anything major, or are they mostly the same? I know someone suggested getting a CTC39 schematic, since that's close too, but it would be nice to get as close as possible.

I obviously need an electrolytic or three, but in order to save a little money here, I'd like to start by replacing only the shorted one, and see if I can save the rest. This set uses several 450V electrolytics, and I can't seem to find appropriate replacements for them at Jameco, and even AES has a very limited selection of higher voltage caps. The caps in this set are very cramped in there, however, getting them out to replace is going to be fun, so I may just go ahead and replace a whole can at once. But, regardless, I do like to figure out _what_ failed before replacing piles of parts. That's part of the fun. I'm going to stop by the library after work and see if I can get the schematic from 1000-3. At least then I'll have a starting point.

It's times like these when I wish that the day was like 36 hours long. Either that or I didn't have to work. Or both. Stupid reality getting in the way of my repairing televisions... Hopefully I'll have time tonight to actually fire up the soldering iron and get some actual troubleshooting done, instead of just staring at the thing

-Ian
Reply With Quote