View Single Post
  #64  
Old 08-04-2009, 12:08 PM
dobulee's Avatar
dobulee dobulee is offline
Electrical Engineer
 
Join Date: Dec 2008
Location: Lancaster, PA
Posts: 52
Ya, some of these as you note, continue to be minor problems.

But, I think I've about reached the point of decreasing returns. I'm not sure I need this to be perfect, just good enough to be enjoyable to watch.

The vertical isn't stretched too badly after adjustment. The 'height' of the test patern squares is almost unchanged from bottom to top. The width at the extreme right is somewhat compressed, as you note. However, with real programming it is barely noticeable.

The resolution is more than focus for me. The IF section has Sub 3Mhz bandwidth right now. At least I can be 100% sure that there is a steep cutoff before 3.5Mhz, because the color carrier is completely stripped off. (check out the color bar staircase from a few posts ago)

Focus isn't terrible, as the scan lines can be made out with uniform clarity across the entire viewing area. Though, again, I don't have any other B/W sets to really compare with.

Hope we both get a few of these things nailed down!
Reply With Quote