View Single Post
  #14  
Old 03-02-2005, 02:57 PM
Bill R Bill R is offline
VideoKarma Member
 
Join Date: Oct 2004
Location: Jackson, TN
Posts: 893
Quote:
Originally Posted by captainmoody
I ran it for a while today, Has a pretty good picture. Vert a bit short and dynamic convergence is off though...
I am not surprised convergance is off, since the yoke is twisted to the right. You should be able to turn it back to the right position and reset convergence without much effort. I do not recall many convergence problems with those sets. I had a table model version of that set. It was ok for a GE.
Reply With Quote