Diodes are a no go. The hv will not work below 100-110v ac input.
The picture tube socket isn't the connector to B+. It's two pins on the yoke socket.
This set should be operating at 387v dc on rectifier under full load at a line voltage of 117 volts ac.
Your present dc is way high... Do you have the yoke plugged in?
Also, disconnecting the speaker plug saves the audio out from dammage because it removes the voltage from both the plate, and, screen. However, the more circuits not functionning, the higher your power supply voltage will be.
Also, that single secion boost filter is important. If open, or, shorted, that kills the vertical, and, damper circuits.
Just completely re-cap it.
And, oh, yes. Those 1kv capacitors on audio out., vertical, yoke, horiz. out., and, damper circuits are very important.
Black beuty caps are no good, either.
Get rid of your line caps, and, resistor if you want real relative safety.
The RF it isolated set from is rarely produced anymore.
Cars now run on alternators. Not generators.
And, who uses a diathermy machine anymore?
No real noticable change in rf in signal without the line caps.
I have alot of experience on these sets, so, if you need my help, please feel free to pm, or, e mail me.
Bill Cahill
__________________
"Tubes are those little glass things that light up orange unless there is a short.. Then they light up all pretty colors..."
Please join my forum.
http://www.tuberadioforum.com/
|