View Single Post
  #2  
Old 07-03-2009, 12:20 AM
dobulee's Avatar
dobulee dobulee is offline
Electrical Engineer
 
Join Date: Dec 2008
Location: Lancaster, PA
Posts: 52
I was replacing caps around the vertical oscillator, and something didn't look quite right --My first schematic change!

Sam's shows the vertical oscillator as a 6J5, where as the RCA chart in the cabinet shows the 6SN7 Dual Version. 1/2 of the 6SN7 is connected exactly as the 6J5 would be, with the other 1/2 pulling duty as the synch amp, where sams shows 1/2 12AU7. The 6SN7 is biased differently than what is shown on the 12AU7, but I guess that is to be expected.

Things get even weirder upstream of that at the DC-Restore/Synch Sep tube, where my chassis bears little resemblance to the Sams schematic. There appear to be both halves of a 12AU7 interconnected up there, where sams shows only 1/2.

I haven't fully traced out that schematic yet, but if I get time, i'll do my best to plot it out.

For what its worth, my Sam's guide for the 6T75 shows chassis KCS47, A; where the actual unit is stamped KCS47AT. Does anybody have this particular schematic? Right now i'm pretty much operating on the 'Blindly replace what is there' technique with no schematic of some sections.

Other than that, a few pics of the re-leaded transformer. Luckily wire is available in all colors under the sun!

Alex
Attached Images
File Type: jpg DSCN0118.jpg (88.9 KB, 43 views)
File Type: jpg DSCN0119.jpg (111.5 KB, 54 views)
File Type: jpg DSCN0121.jpg (96.2 KB, 36 views)
File Type: jpg DSCN0128.jpg (44.7 KB, 37 views)
Reply With Quote