|
Hi Alex, glad to hear it's in good hands.
This is the place to post about it however you might want to start a fresh thread in this forum to document the restoration.
The 16GP4 is a metal tube which can be bad but there's a reasonable chance it's good if it hasn't gone to air, haven't seen that problem much with the 16" tubes.
My avatar is a shot of a 16AP4.
The twist loks are a bit of a pain, some people just disconnect them and add new caps under the chassis. I like to remove them and restuff them where possible for appearances sake. sometimes you can cut the can off without removing it and restuff it right on the chassis.
The cardboard covered ones are the easiest since you don't have to worry about gluing the can back together.
|