View Single Post
  #6  
Old 04-30-2009, 02:51 PM
AUdubon5425's Avatar
AUdubon5425 AUdubon5425 is offline
VideoKarma Member
 
Join Date: Aug 2008
Location: Picayune, Miss.
Posts: 1,769
Did you test the windings with an ohmmeter? Pull the rectifier. Then disconnect the primary lead from the capacitor block, turn the power switch off and see if there's 13 ohms across the primary winding. Do the same for the high voltage secondary, disconnecting the center tap lead (green).

Also, check the rectifier tube socket for signs of arcing. Double check the electrolytics to make sure one wasn't installed the wrong way.

Also, one of those electrolytics may be leaky. To test them, disconnect the positive lead from the capacitor. Set your ohmmeter to the highest range, then test for resistance across the capacitor. If it is leaky it will show a low resistance. A good cap will deflect then read on the high end of the scale - usually 500,000 ohms or better.
Reply With Quote