View Single Post
  #3  
Old 04-30-2009, 11:47 AM
Don Lindsly Don Lindsly is offline
Ex-Philco
 
Join Date: Jul 2005
Location: Colorado
Posts: 450
You will need the correct socket adaptor to go from the Sylvania type on the CRT to the Philco type on the Predicta socket. That has different pin connections from the more popular RCA socket that looks the same. I believe the Philco adaptor socket exchanges the screen and control grids.

The filament current and voltages are different on the Philco tube.

In a series set, the 8YP4 will work OK with the right adaptor socket. It will just take a little longer to warm up to full brightness.

In a transformer powered version, you can jumper the dropping resistor, if used. If it uses a 2.6 volt transformer tap, you can move the CRT filament power to the 6 volt buss TEMPORARILY. Use a clip lead and move it back before reconnecting the 17DRP4.

Don
Reply With Quote