View Single Post
  #7  
Old 02-01-2005, 09:04 PM
RetroHacker RetroHacker is offline
Electronics Accumulator
 
Join Date: Jan 2005
Location: Niskayuna, NY
Posts: 464
Well, I did some work on the set today. I called a local electronic parts store and asked for the thermistor. The guy knew exactly what I was talking to when I asked for a thermistor rated for 120 ohms when cold, and that it was for a television set. He asked me what sort of a set it was for, and when I said that I needed it for a 1969 RCA console, he actually knew precisely the part I needed. He even knew the original RCA part number. Apparently they haven't had anything like that for a long time, but he said that he had a modern RCA replacement that he said should be a usable substitute. So, I went down and picked up the part. May not be exact, but it should work.

I patched up the burned wiring under the chassis, and reconnected the power resistor. It doesn't look like the resistor was damaged, and it still measured the proper value. I also replaced the thermistor with the new substitute.

I plugged the set into my homemade dim bulb tester with a 60 watt light bulb in it. Turn the volume knob a tiny bit, and the indicator on the front of the set lit up, but nothing else. Turn it a little bit more, and the light bulb on the dim bulb tester lit brightly, and the indicator on the front of the set went off. So... I still have a short in there somewhere. I don't dare bypass the bulb in the tester with something like that. I need to do some more thorough investigating. Something tells me that I have a shorted electrolytic (or two). The power resistor that burned off the terminal strip is a 560 ohm unit, and located underneath the chassis, near the shunt regulator tube, with one leg connected to a small transformer under the chassis. Not sure at the moment what part of the circuit that this resistor is part of at the moment, I need to do some more investigating, but that means hauling the chassis back out of the cabinet again.

I was really hoping that I could get away with something simple here, but no such luck. I guess when this television was sitting there awaiting it's destruction, it looked at me like "I can work, honest, take me home, fix me..." Oh well, so - the simple quick fix didn't help this time. I need to pull out the chassis, and really clean out the crud, and sit down and work through the circuit, checking parts. Not to mention repairing the wiring that's managed to break free from the tuner in the process of moving it so much. When I first started, there was a random loose wire that was hanging free from the tuner's relay board. Now I've got another, as well as the cables for some of the knobs on the front of the set that have broken free. It looks like this set's been serviced a bit in the past, and the wiring is getting pretty brittle. I also need to disconnect the electrolytics, check for shorts, and replace what I can. Problem is, this set employs many electrolytics, three of which are large multi-unit cans. Ugh. This is going to get expensive. I just hope the picture tube is good.

-Ian
Reply With Quote