Thread: Variac or not?
View Single Post
  #6  
Old 04-09-2009, 11:01 PM
jeyurkon's Avatar
jeyurkon jeyurkon is offline
VideoKarma Member
 
Join Date: Oct 2008
Location: Central Michigan
Posts: 1,699
Quote:
Originally Posted by Big Dave View Post
Leave the tubes in. I start about 40 volts and raise it by 5 volts every 15 minutes. If a can starts getting warm (not heat transfer from the tubes), I abort. Now, I can reform the lytics. I do disconnect the top cap from the hor out. If the hor out doesn't have a top cap, I tie in the heaters of an equal voltage tube (series string) or remove it.
On the set that I'm concerned with the HOT is a 6BD5GT, so no top cap. The heaters are all parallel so I can just remove the tube.

If I remove the HOT then I want to remove the 6Y6G in the RF HV because I don't want 9.5KV on the CRT if there's no scanning. The rest I would leave in. Well, maybe I'd take out the vertical output, but I think the HOT is the most important one.

Thanks for the info,

John
Reply With Quote