|
Check the voltage at both ends of R007, the 5.6 ohm, 2 watt resistor that I think you replaced. If you have roughly 150 volts on one end; but, nothing on the other, the resistor is open. If you have little or no voltage on either end of the resistor, recheck the voltage at the positive terminal of the large 470 uf, 200 V cap. If you have voltage there but not on resistor R007, there is a problem between the cap and resistor. Maybe the trace is broken.
Did you check the new HOT to make sure it didn't short when you first powered up the set with the new parts?
|