View Single Post
  #9  
Old 03-09-2009, 12:02 PM
Jeffhs's Avatar
Jeffhs Jeffhs is offline
<----Zenith C845
 
Join Date: Feb 2003
Location: Fairport Harbor, Ohio (near Lake Erie)
Posts: 4,035
Quote:
Originally Posted by radiotvnut View Post
Those diodes are probably good. If you are using a digital meter, check them on the diode scale. The likely problem is the chopper transistor (mounted on a heatsink) in the power supply. This transistor likely took out the control IC. In addition, replace the electrolytics in the switching circuit. 39uf, 2.2uf, 15uf, and 470uf. They are all located right there around the IC and transistor. And, check the horizontal output transistor for shorts. It's on a big heatsink close to the flyback transformer.

BTW, don't use NTE, ECG, or any Chinese knock-off parts in this application because they likely will not hold up. Use original RCA parts if possible. www.tritronicsinc.com should have the parts.

IMHO, the CTC169 was the best Thomson era RCA chassis made.
The CTC185xx series isn't half bad either. Once the grounds around the tuner (a major problem with this series, and all CTC-17x-18x series chassis until the CTC203, because of the onboard tuner) are soldered properly, this chassis will run trouble-free for years. Mine has nine years on it and still works as well as when it was new; I had the grounds all resoldered about eight years ago, the last time I had the set serviced. Not a bit of trouble with it since then, and a beautiful picture with the original CRT.
__________________
Jeff, WB8NHV

Collecting, restoring and enjoying vintage Zenith radios since 2002

Zenith. Gone, but not forgotten.
Reply With Quote