View Single Post
  #6  
Old 01-27-2009, 12:15 AM
radiotvnut's Avatar
radiotvnut radiotvnut is offline
VideoKarma Member
 
Join Date: Jul 2007
Location: Meridian, MS
Posts: 6,025
Quote:
Originally Posted by Brian1234 View Post
I had also flipped over to the diode scale while I had them hooked up (no beep in the forward direction). How could they be good if I measured 10Mohms when it should be (near) 0? Either way they're useless now, I clipped the leads then unsoldered the ends. (heh)

The horizontal output transistor is on the big heat sink in the middle of the board... looks a lot like the chopper transistor?
Yep, it's in the center of the board and looks like the chopper transistor. If you check it in circuit, it will show a short between the two end terminals. This is normal. If you measure a short between either one of the end terminals and the center terminal, you have a shorted HOT. If the HOT is shorted, look for a swollen rectangular cap (usually blue) close to the HOT. Maybe you'll get lucky and it will just be the power supply components. And, don't worry about the rectifier diodes. 1N4007's are cheap. I usually order them by the 100.
Reply With Quote