|
The coil is not housed in anything. It's a small round ferrite rod with several turns of wire wrapped around it. It's located behind the HOT heatsink. That coil can look like it's soldered OK but still not make good connection.
You can clip your negative meter lead to the tuner shield, vert. output heatsink, etc. Don't clip it to the heatsink with the power supply switching regulator on it. This is hot ground and will give you false readings. Set your meter to read at least 200 VDC and check the voltage at the collector of the HOT. If you get at least 120 volts or so but no HV; you've either got loose connections or a loss of horizontal drive. Loss of horizontal drive can be caused by, but not limited to, a defective horizontal driver transistor, a defective horizontal drive transformer, or the jungle IC. No B+ will indicate a power supply fault.
|