View Single Post
  #7  
Old 01-17-2009, 12:30 AM
radiotvnut's Avatar
radiotvnut radiotvnut is offline
VideoKarma Member
 
Join Date: Jul 2007
Location: Meridian, MS
Posts: 6,025
Quote:
Originally Posted by Jeffhs View Post
I have two 1980-vintage Zenith radios that were actually manufactured by Zenith subsidiaries in Korea and Taiwan, and in 1982 I had a Zenith four-mode stereo system which was also made in Korea to the specifications of Zenith. I also had two Zenith 13" color TVs and a 12" solid-state portable that were made by Zenith Electronics Corp. of Missouri and by a Zenith subsidiary in Mexico, respectively. My Zenith Sentry 2 19" color TV, built in 1995 (smack dab in the middle of the time frame during which Zenith color sets were turning up in alarming numbers with bad CRTs) was also made by the Zenith Electronics Corp. of Glenview, Illinois, as attested to by a label on the back cover.

Zenith's last table radio was a small AM/FM set, marketed in 1982. I don't know if this set was built to Zenith's specs by a Korean or Taiwanese company, but it probably wasn't manufactured by Zenith itself as the company was pretty much out of the radio business by that time--the radios bearing its name being manufactured offshore. The radio, a table set in a wood (faux wood by then, no doubt) cabinet, was not much to speak of, despite the fact that it had slide controls for volume, bass and treble and a tuning meter. There was also a little gizmo on the back of the radio that Zenith called a "bass booster", although I think this may have been little more than an air chamber which had little or no real effect on the sound. I don't know how well this radio worked, how it sounded or even how many of them were sold, but I do know they show up on eBay every once in a great while....and I mean great while, as in every few months if you're lucky. I guess it either wasn't that great a radio when it was new, or else Zenith didn't sell very many, putting it in the "sleeper" category along with their MJ1035 11-tube AM/stereo FM table radio.
I've seen a few of those early to mid '70's 12" Zenith hybrid B&W's that were made in Taiwan. And, I've had a couple Zenith "all-in-one" stereo systems from the late '70's to early '80's that were Korean built. They were still a decent all-in-one system when compared to the Soundesign, Yorx, Electrophonic, etc. systems that were available at the same time. I've got a little wooden AM/FM Zenith solid state AC table radio from around '68 that I inherited from my uncle when he passed away. IIRC, it was made in the USA. It's a decent performer; but, is built on a PC chassis and is certainly not as well built as their tube models from a few years earlier. My '78 19" Chromacolor II is Mexican; but, my '76 and '77 models are USA built.

As far as my interest in Zenith, it pretty much ends when they discontinued the Chromacolor II's. I might show some interest in the early System 3's depending on the exact model and provided they are clean and the CRT is good. And, I'm sure most will agree that the CCII chassis was easier to troubleshoot than the System 3 chassis. I really don't think Zenith intended for the System 3 chassis to be repaired at the component level. They expected the entire board to be changed. That's all fine and good; but, those System 3 boards were quite expensive.

OK, I'm done for now.
Reply With Quote