View Single Post
  #21  
Old 12-25-2008, 12:05 AM
radiotvnut's Avatar
radiotvnut radiotvnut is offline
VideoKarma Member
 
Join Date: Jul 2007
Location: Meridian, MS
Posts: 6,025
You probably have a bad splitter. The ones I've changed on the CTC169/179 chassis would arc and have lines in the picture if the HV wires were not seated properly in the splitter. And, yes, those wires are a pain to seat correctly. An ex-TV repaiman friend of mine who recently retired from TV repair told me than when they suspected a shorted splitter, he would disconnect the flyback HV lead from the splitter and poke the wire down inside a clean bottle, etc. to prevent it from arcing to something. He would turn the set on and if it powered up, the splitter was shorted. This little trick was good for the older RCA big screens. Maybe someone will chime in and tell us if the same trick is good for this chassis. I don't see why it wouldn't be. If you change the splitter, get an original RCA. Don't buy any of those cheap generic knock-offs. They will turn around and bite you in the butt in short order. I made the mistake of using a knock off splitter in a CTC179 chassis RCA bigscreen that I wanted to sell. It worked for a few months and then that one started arcing just like the original one. I used an RCA original the next time and will never use a generic again. Actually, I probably won't be using any of them again because I've about had my fill of working on big screen TV's. I might feel different if they didn't weigh 9 tons and take up so much room.
Reply With Quote