View Single Post
  #6  
Old 12-16-2008, 06:56 PM
Reece's Avatar
Reece Reece is offline
VideoKarma Member
 
Join Date: Jul 2004
Location: Cleona, PA
Posts: 2,178
Tom has referred you to his service notes which are excellent help for repairing this radio. I just want to pass along a way to determine if your transformer is OK.

If the dial light lit up then there should be power to the tube heaters since they're on the same transformer winding. What you can do to test the transformer: be sure the power cord is safe, change it out if required. Rectifier tube should be removed, which it is in this case! Turn the power on and listen, watch, sniff, around the transformer. If all seems calm, measure across pins 3 & 5 (the plates) of the 5Y4 socket: these should be yellow wires coming from the transformer. You should get several hundred volts AC if all is OK. Measuring between either yellow wire and the yellow-green center tap you should get about half of the previous reading.

Xfrmr still not complaining? Hope you're wearing sneakers and standing on a rubber mat. Put one hand in your back pocket and feel the xfrmr shell. Old radioman trick, that's how they got to be old, not making a complete circuit across the heart. Not hot yet, good. Test the other windings: the filament winding to the rectifier should be 6 or 7 volts, the winding for the heaters of the other tubes, if they are working, 6 volts or so, in that ballpark.

If all is still OK, leave the power on for about half an hour but watch it carefully, don't leave it. Transformer should only get a little warm to the touch in that time if it's not shorted.

As stated before, after getting tubes sorted out, I wouldn't fire it up again without replacing caps, especially the 'lytics. And checking all components, resistors, inductors, in the power supply. There is always the possibility that something shorted and took out the rectifier tube. Next time it could take out the transformer if not fixed first.

Good luck and have fun!
Reece
__________________
Reece

Perfection is hard to reach with a screwdriver.
Reply With Quote