The total value of those 5 22-5001 caps in parallel is the same as the 880-860 4 lead cap...which if memory serves me correctly is .01uF.
Anyhoo, all you need to do is remove all 5 of those caps, and install and 800-860 in their place.
At 1 end of the cap, 1 lead will go to B+, and the other will go to the collector of the horizontal output transistor. You will need to open the line that goes from the flyback to the collector of the HOT, and insert the cap in the circuit.
At the other end of the cap, 1 lead will go to ground and the other will go to the emitter of the horizontal output transistor. You will need to open the emitter circuit and insert the cap there.
When the original 22-5001 cap became unavailable (it came in bags of 5), we routinely did this in our shop with excellent results.
Another method I have seen others use was to twist the leads together at each end of the 4 lead cap, and solder it in place of 1 of the old caps (after removing all of the old caps.) THIS IS NOT RECOMMENDED! The idea with the 4 lead cap is that if it fails, it will open the path of conduction from either the collector or emitter, thereby killing the high voltage. The idea with the 5 original individual caps was that they wouldn't all fail at the same time. They did.
The 800-860 cap can still be found on Ebay.
To Charles...
Too MUCH high voltage will not cause blooming. Too little will. Too much will cause underscan of the raster and, sometimes, arcing in the CRT. A CRT's deflection sensitivity goes up as the high voltage goes down, hence the increased raster size with dropping high voltage. You are correct that blooming is caused by poor regulation, however. As beam current increases, it drags down the high voltage, and the result is blooming.
Good luck guys.
ETA... All of these, and other, safety caps are available here-
http://cgi.ebay.com/2-pcs-Hi-Voltage...2em118Q2el1247.