View Single Post
  #4  
Old 11-11-2008, 01:38 PM
Jeffhs's Avatar
Jeffhs Jeffhs is offline
<----Zenith C845
 
Join Date: Feb 2003
Location: Fairport Harbor, Ohio (near Lake Erie)
Posts: 4,035
Quote:
Originally Posted by Chad Hauris View Post
I have had several cases where volume controls went open and I had to replace them....sounds like maybe the carbon track or wiper is open inside the control. First thing I would do is put the ohmmeter on the control (disconnected from the circuit) and check from wiper to each end terminal and across the end terminals.
It will probably be harder to replace the control on a radio like this as opposed to on, say a 1940's console radio as the shaft may be insulated to avoid a hot chassis shock hazard and also it may be a half-moon type to fit the knob.
I had a feeling the volume control was going to fail eventually, since it had been extremely intermittent almost from the time I got the radio last year.

The volume control in the MJ1035 is a 2-megohm dual pot. I don't know if these are available anymore, after 43 years. If they can still be found, where can I find a replacement? If not, is there a suitable substitute for it, even a single pot for just one stereo channel? I'm not really interested in restoring the stereo function, as I already have a reasonably good stereo system; if I can get the MJ1035 working in mono, that will be good enough for me, as I use it for background music only at this time.

BTW, I am not aware of any special precautions Zenith took with the MJ1035 to insulate the control shafts from the chassis, but the control does have a half-moon shaft on the inner control for right channel volume. (The left channel pot has a shaft that fits over the inner shaft.) If necessary, I could replace the knob with a setscrew type knob from my junk box.

Thanks in advance.
__________________
Jeff, WB8NHV

Collecting, restoring and enjoying vintage Zenith radios since 2002

Zenith. Gone, but not forgotten.
Reply With Quote