View Single Post
  #91  
Old 11-06-2008, 12:59 PM
radiotvnut's Avatar
radiotvnut radiotvnut is offline
VideoKarma Member
 
Join Date: Jul 2007
Location: Meridian, MS
Posts: 6,025
I have increased the heater voltage to bring back old tubes, especially ones that had not been used in years. The normal filament voltage is 6.3. I usually use around 8 volts. Most TV parts suppliers sell brightners that can be soldered between the filament winding of the flyback and the CRT filament that will boost the filament voltage.

Before you buy a brightner, connect an 8 volt source to the filament and let it cook for a half hour or so. Then, remove the power source and connect the CRT for normal operation and see if it looks better.
Reply With Quote