|
Alright well I have changed just about every cap on this set that has a strange/high esr reading. The power supply has also been totally recapped.
The noise in the power supply still exists. I've noticed it only starts up when you apply an actual video signal to the projector. Then the power supply starts it's buzzing.
I've also noticed that the power supply shuts up when you put your hand on the frame. I've considered putting a ground wire to the frame. Good idea??
Theres one more cap I am going to change. It's a small one but the only other one I can remember giving any sort of bad reading. After this I will run the set for 3 hours.
The only reason I havn't already is because of the power supply noise and how quickly some of those resistors in the power supply get HOT.
If anyone could tell me there thoughts here. Should I put a Ground to the frame? Is the power supply acting more or less normal? Should I go for the 3 hour test?
Any thoughts would be much appreciated. Or else I"m just gonna continue on with my plans and hopefully not destroy the thing..
If you think it's a good idea wish me luck
Thanks
Rudy
|