View Single Post
  #9  
Old 10-30-2008, 11:27 AM
zenithfan1's Avatar
zenithfan1 zenithfan1 is offline
Mark
 
Join Date: Jan 2008
Location: Kenosha, Wisconsin
Posts: 4,211
Good advise Marty, one other thing, when working on sets with circuit boards, always be careful when wiggling or removing tubes. If one is really tight or seems stuck, spray a LITTLE de-oxit at the base of the tube first. This will penetrate and make it easier to remove. The more hours on a set the more brittle those boards become from the heat. The board can crack and break without notice. You can check for "tube scorch" by looking at the surrounding area of the socket. Most boards are green on the bottom and brown on the top in vintage sets, if you see these areas turning dark brown or black, use extreme caution. Most of the time it happens around shielded tubes or horizontal/vertical output tubes as these get really hot. If you plan to use the set regularly, it might be advisable to point a fan at the back to keep it running cooler. This is one more reason I am a big fan of the "Handcrafted chassis" point to point method used by Zenith. No boards at all, only solid steel!
__________________
My TV page and YouTube channel
Kyocera R-661, Yamaha RX-V2200
National Panasonic SA-5800
Sansui 1000a, 1000, SAX-200, 5050, 9090DB, 881, SR-636, SC-3000, AT-20
Pioneer SX-939, ER-420, SM-B201
Motorola SK77W-2Z tube console
McIntosh MC2205, C26
Reply With Quote