|
Ya Know for 10$ I wasn't expecting it to be HDTV that could project on the side of a building. I knew it would be like a normal CRT tv at best.
And just from watching the red on the wall completely unadjusted and a lit room. I have no doubt this projector will suit my needs.(Play nintendo haha)
And I have a question for you Mbates14.
The power supply on your unit. Is it normally quiet?
Mine is making a ticking/buzzing sound. And also after a short run time the large resistors will already have considerable heat on them. Could a bad cap in the power supply cause any type of noises?
And would a weak power supply maybe explain why the tubes seem weak.
I've thought it over and no one could have possibly watched this unit till the green was as weak as it is showing right now. Maybe they put it aside due to failure of something else? Like the power supply?
Woah hoah hoah
After remembering the unit was mounted upside down. Suddenly all these brown burn looking marks made sense. On the raster regulator there are 9 vari pots.
The 3 on the bottom were seized. And under each one it was charred brown. Before this made no sense to me. These burns appeared to start from nowhere and end nowhere so I disregarded them. But now it makes sense. Because the heat and smoke was traveling the opposite way I thought. So I have some cooked pots I think. Mbates14 is there were you had to rewind the pots? by chance
Actually(after another quick check) this vari pot idea makes way to much sense. Of the three that are cooked, RED(my only well working color) can still turn.
Blue and Green Vari pots for this adjustment were seized and the plastic knobs snapped off.(With little effort) This finding just makes too much sense.
Anybody else have thoughts?
Thanks for your time
Rudy
Last edited by JesusJones; 10-24-2008 at 06:14 PM.
Reason: Realizeations....
|