Thank you every one.
And yes after I found out this projector was made in the first year Zenith began making these. I knew it would not be very great, but I thought it would just be fun to toy with. And if it did work half as well as I thought for 10$ it woulda been a steal.
I'm gonna check for mold. Mold would be a god send. (easy inexpensive fix)
Mbates14 You mentioned the splitter assembly. What part is this more specifically?
And I have seen "One" schematic for this projector, but you had to buy it. Other than that I have looked and looked(You probably have to) And it's impossible to find.
This is the page
http://www.analogalley.com/m_zenith.htm
I didn't wanna pay for it. Just so i could be sent the wrong one.
And the HV goes to a splitter. Here at the splitter are some controls. (For each tube.)
From playing with them I have noticed they make the color brighter or dimmer.
There is Low medium and High jumper and then a vari pot to fine tune.
Blue and Red were set to medium. And green was set at high when I opened it.
This leads me to beleive the tube was most likely cranked up higher and higher till death(Shucks) (Or maybe there was just more and more mold!)
Also upon starting the unit during the nite I Noticed HV arcing to the frame.It was not intense and stopped after a second or two. But maybe this is a sign of something?
Oh and I got the picture right side up by changing the yoke pin connections. Now it's rightside up. No miracles there
Rudy