Quote:
Originally Posted by AndrewM
Not many B&W sets in Australia had hot chassis. Those that did used a few different methods to drop the supply voltage for the heaters. One popular method was to use a diode in series with the heaters to give 110v half wave AC.
I'm surprised to see "our" 3 pin socket used in the US. Since the voltage is similar I guess they considered it safe to use there especially since Australian spec electrical equipment would be most unusual in the US.
|
A diode in the heater string would yield the equivalent of 155V out of 220V on the heaters. This gets confusing, but power=volts squared/resistance. A diode will halve the power if the voltage is AC powerline. Half of 220^2 = 155^2. The ratio works out to 1/(square root of 2)=0.707
Below are a few more pictures of the American Australia style power plug. These are no longer manufactured, but they were briefly in the early 50's. The ratings say 15A 125V or 10A 250V. And pictures showing a comparison between an Aussie plug and the American made one. And a strange adapter. In my mom's house the few in use
have 125Vac on both current carrying pins, \ and /, but with both AC waveforms 180 degrees out of phase of each other, to give me 250Vac. The | pin is the safety ground. I have an Australian made radio:

which is quite happy plugged into this outlet.