View Single Post
  #13  
Old 10-05-2008, 03:42 PM
radiotvnut's Avatar
radiotvnut radiotvnut is offline
VideoKarma Member
 
Join Date: Jul 2007
Location: Meridian, MS
Posts: 6,025
That part is known as a safety capacitor and is a high failure part in Magnavox sets of that vintage. Unfortunately, they are hard to find today and one probably wouldn't last that long if you did find one. The last time I ran into this situation, I used two orange drop caps of the correct working voltage in parallel to give me the correct value. You'll notice a total of four leads on the original cap. The two leads on each end are tied together (a short) inside the cap. Just jump these end connections on the PC board when you install the new capacitor.

I did this to a 19" set and it seemed to work OK. I sold the set and it never came back; so, I guess it held up.
Reply With Quote