View Single Post
  #167  
Old 10-03-2008, 01:51 PM
JesusJones JesusJones is offline
AK Member
 
Join Date: Dec 2007
Posts: 187
Quote:
Originally Posted by electroking View Post
Once you get the power supply fixed (and take the time to do it right!),
you will learn to use the width (R-452) and height (R-421) controls
to adjust those things as needed. Good night.
The height is Ok I think. It seems to be working better.

But the width is another story. I originally had a problem with this variable pot. So I switched it out and put a 5K as a temp. fix. This brought my HV back and I continued troubleshooting.

Now the 5 k pot in there was not enough to make the screen narrow enough. So I put resistors in there ( 3k 5k 10k) Untill it would get narrower.

But it never got narrower. I left the 10 k and the pot adjusted to full and the screen doesn't even looks like it got much narrower at all. The horizontal hold at the front of the TV does more to narrow it.(Or it just moves the picture over to the left and right)

More resistance or what?
Thanks
Rudy


So I ran the TV for about 20 minutes today. Played some Nintendo. Here's the verdict.

Mario was very very short at the bottom of the screen. And Mario was very very tall near the top of the screen. Fun game

And also the general picture was off the screen. Like I said before, the top of the screen is off the screen, by the time the bottom of the screen actually reaches the bottom.
The top is stretched, the bottom is compressed. I tried fiddling with ALL the controls. It cant be set properly.
Recapping the vertical or what needs to be done. Has some one had similar problems?
And also the fusible resistor is still getting rather hot. To hot to touch. The TV did hold up for the 20 minutes though.
Thanks
Rudy
Reply With Quote